Advanced · 4/6

Hardware and connectivity

Evocon IIoT device, sensors, wiring and network.

1. 1Hardware (Evocon device)Overview page with links to Evocon IIoT device 3 resources and troubleshooting guides.
2. 2Hardware - Evocon IIoT device 3.0 - Technical specification and user manual
3. 3Hardware - Evocon IIoT device 3 - How to connect a sensorWhich sensor types can be used with the Evocon IIoT device 3 and how to wire a PNP 24V DC sensor to its M12 inputs.
4. 4Hardware - Evocon IIoT device 3 - How to connect a relayWhy and how to use a relay (preferably solid-state) between manufacturing equipment and the Evocon IIoT device 3, with the M12 pinout and a wiring diagram.
5. 5Hardware - Evocon IIoT device 3 - How to connect an analog signalHow to wire a 0…10V analog signal to Input 3 of the Evocon IIoT device 3, remove the 0V jumper, and use the timer-triggered or input-triggered analog modes.
6. 6Hardware - Evocon IIoT device 3 - Signal connection drawingsWiring drawings for the most common ways to connect signals to the Evocon IIoT device 3: sensor, PLC via relay, copied sensor signal, parallel signals and production/setup split.
7. 7Hardware - Evocon IIoT device 3 - Analogue input calibration guideStep-by-step calibration of the analogue input (Input 3) ADC of the Evocon IIoT device 3 using the S301 and S400 buttons, and how to check the result in the CLI.
8. 8Hardware - Evocon IIoT device 3 - Networking configurations and capabilitiesNetwork capabilities of the Evocon IIoT device 3, how it communicates with Evocon and AWS IoT, which hostnames to allow in the firewall, and static IP, proxy and WiFi requirements.
9. 9Hardware - Evocon IIoT device 3 - Interface to configure IP and WiFi settingsHow to connect to the Evocon IIoT device 3's own WiFi network and use its web interface at 192.168.4.1 to set WiFi networks, static IP and DNS.
10. 10Hardware - Evocon IIoT device 3 - Interface to configure IP and WiFi settingsHow to connect to the Evocon IIoT device 3's own WiFi network and use its web interface at 192.168.4.1 to set WiFi networks and static IP.
11. 11Hardware - Evocon IIoT device 3 - Command line interface (CLI)How to connect a PC to the Evocon IIoT device 3 over micro-USB, log in to its command line interface and use the WiFi, input and general configuration commands.
12. 12URLs required for the Evocon device connectivityHostnames, IP addresses, protocols and ports that Evocon IIoT Device 3.0 needs to reach through the firewall, and the TLS-inspection restriction.
13. 13URLs required for the Evocon system connectivityRequired and optional addresses and ports (app.evocon.com, api.evocon.com, AWS Cognito, Appcues, HubSpot) that browsers need to use the Evocon application.
14. 14Steps to follow in case the Evocon device is offlineHow to check the lights, cabling and network of an offline Evocon device and what to send to Evocon support.
15. 15Using DevicesHow to use the Devices overview and device view in Settings to check the status of your Evocon devices and inputs.